Pre-Wired Guitar wiring harness | 3-way Telecaster kit | Left Handed w/LH taper & Treble Bleed

£64.99 £58.49

Description
The Telecaster is an iconic instrument, that defined a brand, inspired so many musicians and set the bar for the electric guitar moving forward. I want my Signature Series wiring harness for this legendary guitar to earn the right to be a small part of that through a choice of quality components and respect for it's design. The schematic is a simple recipe, and the parts aim to bring out the best in your telecaster's tone, and aim to do so for many years to come. 
I have been offering left handed harnesses for a while, and also have been speaking with left handed players to find out what they prefer, or what they wished was available. So I have decided to offer the LH Tele harness with either left handed or right handed audio taper pots depending on your preferences. Through my research I found that the majority of guitar factories that produced LH guitars simply installed regular RH taper pots. Meaning many LH players were used to using RH taper. But for some it never felt intuitive to use and wished they could use LH taper pots instead. So I hope offering both versions helps you!
Not sure whether Left Handed/Reverse audio taper pots are 'right' for you? Check out this article I put together addressing the subject, and hopefully it will help you find the correct choice for your playing. HERE

Installing
I have intended for my wiring harnesses to be as simple as possible to install to your Telecaster, as well as writing in depth fitting guides, how-to instructions documenting the step by step process as well as a simple to follow wiring diagram.
The parts I use, in particular the pots, are CTS branded pots which are imperial measurements. If you're fitting this harness to a far east built variant for example such as a Squier or similar, then you may have to widen the holes in the control plate to accommodate for these imperial measurement pots. Or alternatively, purchase a new control plate that is already suited to the US spec components. 
For reference, the CTS pots I use in this harness have a shaft diameter of 9.52mm.
You may also require new control knobs to fit the CTS pot 'solid shaft' diameter of 6.35mm.
If you do require a US spec control plate or control knobs, we do carry a selection of popular options in stock and they can be viewed in the hardware & plastic hardware categories on the store.

Centre to centre measurements between components are - 
Centre of Switch to volume pot - 40mm
Centre of volume pot to centre of tone pot - 64mm
These measurements for my templates were taken from a USA Fender telecaster control plate.

Parts used
- LH taper option - CTS 250k audio LH Taper pots SPLIT SHAFT (Please note that if you require solid shaft pots, CTS don't make a LH taper solid shaft pot unfortunately. So you'll need brass sleeves to convert to solid shaft if your control knobs fix by grub screw rather than push fit.)

- .022uF 'Yellow Mustard' type tone capacitor
- Gavitt USA made cloth covered 22AWG wire
- 20AWG Tinned copper ground
- CRL 3 way spring loaded lever switch
- Pure Tone multi contact jack socket
- Soldered using Rapid 22SWG lead-free solder
- .001uF & 120kOhm treble bleed mod

This kit is made and ready to ship!